Introduction
All Maple Systems HMIs programmed with EBPro (EasyBuilder Pro), including every cMT X Series and cMT Series model, are compatible with Cimon CM1-CP4A/ECO1A. Configure your Controller and HMI/cMT with the following parameters to establish reliable communication.
Supported Series: Cimon CM1 series, CP4A module
HMI Setting
| Parameters | Recommended | Options | Notes |
|---|---|---|---|
| PLC type | Cimon CM1-CP4A/ECO1A | ||
| PLC I/F | RS232 | ||
| Baud rate | 38400 | ||
| Data bits | 8 | ||
| Parity | None | ||
| Stop bits | 1 | ||
| PLC sta. no. | 1 |
Device Address
| Bit/Word | Device type | Format | Range | Memo |
|---|---|---|---|---|
| B | X | DDDDh | 0 ~ 1023f | 0-1F Read Only |
| B | Y | DDDDh | 0 ~ 1023f | |
| B | M | DDDh | 0 ~ 511f | |
| B | K | DDDh | 0 ~ 127f | |
| B | L | DDDh | 0 ~ 127f | |
| B | F | DDDh | 0 ~ 127f | Read Only |
| B | T | DDDh | 0 ~ 102f | |
| B | C | DDDh | 0 ~ 102f | |
| W | D | DDDD | 0 ~ 9999 | |
| W | S | DD | 0 ~ 99 | Max. Range: 99 |
| W | TS | DDDD | 0 ~ 1023 | |
| W | TC | DDDD | 0 ~ 1023 | |
| W | CS | DDDD | 0 ~ 1023 | |
| W | CC | DDDD | 0 ~ 1023 |
Wiring Diagram
NOTE: The serial port pin assignments may vary between HMI models.
RS-232 (CM1-CP4A: 6P RJ11)
| HMI | Direction | PLC |
|---|---|---|
| Pin assignments | RS232 6P RJ11 | |
| Rx | ↔ (bidirectional) | 2 TX |
| Tx | ↔ (bidirectional) | 3 RX |
| GND | ↔ (bidirectional) | 5 GND |