5.6″ Graphic HMI, Non-Ethernet

We created this short video showing how easy it is to upgrade your project using EBPro. In this video, we chose to upgrade our HMI5070Pv2 to a cMT3072XHT as an example. If you are upgrading to HMI5070Bv4, you can ignore this section. 

There are some differences in how your project will be programmed compared to the previous HMI project.

• If your new HMI comes with a higher resolution than the legacy HMI, the aspect ratio will be different. EBPro will scale your images accordingly, however, if they do not look high quality you will need to reimport them into your project.
• Layered objects are not supported, the same functions can be achieved using Combo Buttons in EBPro.
• General mode security is disabled but data is retained and will be active in Enhanced Security settings. It is recommended that you switch to Enhanced security for remote access purposes.
• System keypads are built-in.
• Some objects have new, or different, settings.

Converting your Legacy Product to a Newer HMI document was created to step you through the above mentioned differences.

No panel cutout modifications needed. Our 7″ HMIs were designed to fit into existing 5.6″ cutouts.

Additional Information

• Video Center
• Controller Connection Guides
• Communication Cables
• Software Tutorials
• Converting from EZware Plus to EBPro