I’m having trouble downloading to or configuring my HMI+PLC (HMC) using a USB cable – Download Issue/Error/Problem

If you experience difficulty downloading to an HMI+PLC (HMC) from MAPware-7000 with a Windows^® 10 operating system, you may need to re-install the MAPware-7000 USB Drivers. The MAPware-7000 USB drivers are located in the folder: C:MapleSystemsMAPware7000USB Drivers. Refer to Tech Note 7017, “Reinstall MAPware-7000 USB Drivers” for full instructions on how to delete and reinstall the USB driver. Also, make sure you are using a USB 2.0 port on your PC to download to the HMI+PLC. USB 3.0 is not supported.

Software Downloads & Upgrades

• MAPware-7000

Tech Notes

• Upload a Project to a USB Flash Drive from an HMC
• Download a Project to an HMC from a USB Flash Drive
• Uploading Logged Data to a USB Flash Drive
• Reinstall MAPware-7000 USB Driver

Manuals & Guides

• HMC Series Installation Guide
• MAPware-7000 Programming Manual
• MAPware-7000 Ladder Logic Guide
• Mapware-7000 Getting Started Guide
• HMC3000 I/O Module Guide
• HMC7000 I/O Module Guide
• MAPware-7000 IEC61131 Programming Guide

Videos

• Product Overview
• Part 1: Introduction and Installation
• Part 2: Creating a Native Ladder Project
• Part 3: Adding and Initializing Tags
• Part 4: Adding Logic
• Part 5: Creating an HMI Screen
• Part 6: Duplicationg an HMI Screen
• Part 7: Downloading and Testing the Project
• Part 8: Creating an IEC Project
• Part 9: Creating a UDFB
• Part 10: Adding a Structure Text UDFB
• Part 11: Adding Power Up and Main Routine Logic
• Part 12: Creating Screen Objects
• Part 13: Downloading the Project and Online Monitoring

Controller Information Sheets

• Controller Information Sheets

Communication Cables

• Communication Cables