Introduction
All Maple Systems HMIs programmed with EBPro (EasyBuilder Pro), including every cMT X Series and cMT Series model, are compatible with JTEKT Toyopuc PCk05. Configure your Controller and HMI/cMT with the following parameters to establish reliable communication.
Supported Series: JTEKT Toyopuc PCk05
Website: http://www.jtekt.co.jp/
HMI Settings
| Parameters | Recommended | Options | Notes |
|---|---|---|---|
| PLC type | JTEKT Toyopuc PCk05 | ||
| PLC I/F | RS232 | ||
| Baud rate | 9600 | 9600, 19200, 38400 | |
| Data bits | 8 | ||
| Parity | Odd | Odd, Even, None | |
| Stop bits | 1 | 1, 2 | |
| PLC sta. no. | N/A |
Device Address
| Bit/Word | Device type | Format | Range | Memo |
|---|---|---|---|---|
| B | K_Bit | Hh | 0 ~ ff | |
| B | V_Bit | Hh | 0 ~ ff | |
| B | T_Bit | Hh | 0 ~ 7f | |
| B | 1C_Bit | Hh | 0 ~ 7f | |
| B | L_Bit | HHh | 0 ~ 7ff | |
| B | X_Bit | Hh | 0 ~ ff | |
| B | 4Y_Bit | Hh | 0 ~ ff | |
| B | M_Bit | Hh | 0 ~ ff | |
| B | 4M_Bit | Hh | 0 ~ ff | |
| B | S_Bit | HHh | 0 ~ 7ff | |
| B | N_Bit | HHh | 0 ~ 7ff | |
| B | 1N_Bit | HHh | 0 ~ 7ff | |
| B | D_Bit | HHHh | 0 ~ cfff | |
| W | K | H | 0 ~ f | |
| W | V | H | 0 ~ f | |
| W | T | H | 0 ~ 7 | |
| W | 1C | H | 0 ~ 7 | |
| W | L | HH | 0 ~ 7f | |
| W | X | H | 0 ~ f | |
| W | 4Y | H | 0 ~ f | |
| W | M | H | 0 ~ f | |
| W | 4M | H | 0 ~ f | |
| W | S | HH | 0 ~ 7f | |
| W | N | HH | 0 ~ 7f | |
| W | 1N | HH | 0 ~ 7f | |
| W | D | HHH | 0 ~ cff |
Wiring Diagrams
NOTE: The serial port pin assignments may vary between HMI models.
The view from the soldering point of a connector.
RS-232 (CPU Port1 and Port2)
| HMI | Direction | PLC |
|---|---|---|
| Pin assignments | RJ12 RS232 | |
| Rx | ↔ (bidirectional) | 4 |
| Tx | ↔ (bidirectional) | 3 |
| GND | ↔ (bidirectional) | 1 |