Introduction
All Maple Systems HMIs programmed with EBPro (EasyBuilder Pro), including every cMT X Series and cMT Series model, are compatible with SEW Movilink. Configure your Controller and HMI/cMT with the following parameters to establish reliable communication.
Supported Series: SEW Eurodrive series, model MOVITRAC-07 inverter, MovitracB
Website: sg.sew-eurodrive.com
HMI Settings
| Parameters | Recommended | Options | Notes |
|---|---|---|---|
| PLC type | SEW Movilink | ||
| PLC I/F | RS485 2W | ||
| Baud rate | 9600 | ||
| Data bits | 8 | ||
| Parity | Even | ||
| Stop bits | 1 | ||
| PLC sta. no. | 0 | 0~255 |
Device Address
| Bit/Word | Device type | Format | Range | Memo |
|---|---|---|---|---|
| B | INDEX_Bit | DDDDDDDDdd | 0 ~ 2552500031 | |
| W | INDEX | DDDDDDDD | 0 ~ 25525000 |
NOTE: The MOVITRAC-07 doesn’t support Sub index (other series may support); please input 000.
NOTE: When entering D and d values, the correct format is: Sub index 15, Index 8359, formatted as 01508359.
Wiring Diagrams
NOTE: The serial port pin assignments may vary between HMI models.
RS-485 2W
The view from the soldering point of a cable.
| HMI | Direction | PLC |
|---|---|---|
| Pin assignments | Movitrac 07 RS485 2W | |
| Data- | ↔ (bidirectional) | D-(Green) |
| Data+ | ↔ (bidirectional) | D+(Red) |
| GND | GND |