Introduction
All Maple Systems HMIs programmed with EBPro (EasyBuilder Pro), including every cMT X Series and cMT Series model, are compatible with LS Electric Metronix AnyPack. Configure your Controller and HMI/cMT with the following parameters to establish reliable communication.
Protocol: LS Mecapion Metronix AnyPack
HMI Settings
| Parameters | Recommended | Options | Notes |
|---|---|---|---|
| PLC type | LS Mecapion Metronix AnyPack | ||
| PLC I/F | RS232 | ||
| Baud rate | 9600 | ||
| Data bits | 8 | ||
| Parity | None | ||
| Stop bits | 1 | ||
| PLC sta. no. | 0 |
Device Address
| Bit/Word | Device Type | Format | Range | Memo |
|---|---|---|---|---|
| B | MD_Low_16bit |
DDDDDdd | 0 ~ 9999915 | |
| B | MD_High_16bit |
DDDDDdd | 0 ~ 9999915 | |
| B | MD_Low_16bit_s |
DDDDDdd | 0 ~ 9999915 | |
| B | MD_High_16bit_s |
DDDDDdd | 0 ~ 9999915 | |
| DW | MD |
DDDD | 0 ~ 9999 | |
| DW | MD_WSS |
DDDD | 0 ~ 9999 |
Wiring Diagram
NOTE: The serial port pin assignments may vary between HMI models.
RS-232
| HMI | Direction | PLC |
|---|---|---|
| Pin assignments | RS232 Terminal |
|
| Rx | ↔ (bidirectional) | 6 |
| Tx | ↔ (bidirectional) | 5 |
| GND | ↔ (bidirectional) | GND 11 GND 12 |