Introduction
All Maple Systems HMIs programmed with EBPro (EasyBuilder Pro), including every cMT X Series and cMT Series model, are compatible with Fuji NB Series. Configure your Controller and HMI/cMT with the following parameters to establish reliable communication.
HMI Settings
| Parameters | Recommended | Options | Notes |
|---|---|---|---|
| PLC type | Fuji NB Series | ||
| PLC I/F | RS485 4W | ||
| Baud rate | 19200 | ||
| Data bits | 8 | ||
| Parity | Odd | ||
| Stop bits | 1 | ||
| PLC sta. no. | 0 |
PLC Settings
| Parameter | Value |
|---|---|
| Communication mode | NITP Protocol / PLC Password (default is 0) |
Device Addresses
| Bit/Word | Device Type | Format | Range | Memo |
|---|---|---|---|---|
| B | Y | HHH | 0 ~ 7ff | Output Relay |
| B | X | HHH | 0 ~ 3ff | Input Relay |
| B | M | HHH | 0 ~ fff | Internal Relay |
| B | L | HHH | 0 ~ fff | Latch Relay |
| B | C | HH | 0 ~ ff | Counter |
| B | M_Spe | HHHH | 0 ~ 81ff | Special Relay |
| B | T | HHH | 0 ~ 1ff | Timer |
| W | TV | HHH | 0 ~ 3ff | Timer value |
| W | CV | HHH | 0 ~ 3ff | Counter value |
| W | D | HHHH | 0 ~ 1fff | Data Register |
| W | D_Spe | HHHH | 0 ~ 81ff | Special Register |
Wiring Diagram
NOTE: The serial port pin assignments may vary between HMI models.
RS-485 4W (Fuji NB Series RS422 8P RJ45 Male)
| HMI | Direction | PLC |
|---|---|---|
| Pin assignments | Fuji NB Series RS422 8P RJ45 Male | |
| Rx- | ↔ (bidirectional) | 4 |
| RX+ | ↔ (bidirectional) | 3 |
| Tx- | ↔ (bidirectional) | 6 |
| Tx+ | ↔ (bidirectional) | 5 |
| GND | ↔ (bidirectional) |