Connection Parameters Needed for HMI/cMT Products to Communicate with Fanuc 0i/30i/31i/32i/35i Series using EBPro (EasyBuilder Pro)

Introduction

All Maple Systems HMIs programmed with EBPro (EasyBuilder Pro), including every cMT X Series and cMT Series model, are compatible with Fanuc 0i/30i/31i/32i/35i Series. Configure your Controller and HMI/cMT with the following parameters to establish reliable communication.

Supported Series: Fanuc 0i/30i/31i/32i/35i Series

Website: http://www.fanucfa.com/welcome_worldwide/

HMI Settings

Parameters	Recommended	Options	Notes
PLC type	Fanuc 0i/30i/31i/32i/35i Series
PLC I/F	RS232
Baud rate	19200
Data bits	8
Parity	Even
Stop bits	1
PLC sta. no.	0
On-line simulation	YES

PLC Setting

Reader/Puncher interface (2ch.) is used for touch panel interface.

External touch panel interface, S/N: A02B-0320-J685, for Power Mate Series.

Device Address

Bit/Word	Device type	Format	Range	Memo
B	`X`	`DDDDo`	0 ~ 11277
B	`Y`	`DDDDo`	0 ~ 11277
B	`K`	`DDDo`	0 ~ 9997
B	`E`	`DDDDo`	0 ~ 99997
B	`D_Bit`	`DDDDo`	0 ~ 99997
B	`R_Bit`	`DDDDo`	0 ~ 94997
W	`T`	`DDDD`	0 ~ 9499	Must be a multiple of 2
W	`C`	`DDDD`	0 ~ 5199	Must be a multiple of 4
W	`D_Byte`	`DDDD`	0 ~ 9999
W	`R_Byte`	`DDDD`	0 ~ 9499
W	`D`	`DDDD`	0 ~ 9999	Must be a multiple of 2
W	`R`	`DDDD`	0 ~ 9499	Must be a multiple of 2

Wiring Diagram

NOTE: The serial port pin assignments may vary between HMI models.

RS-232

The following is the view from the soldering point of a connector.

20-pin communication port connector for Fanuc 0i/30i/31i/32i/35i Series, showing two rows of numbered pin positions 1–9 and 11–20.

HMI	Direction	PLC
Pin assignments		RS232 20P JD36B or JD54 Female
Rx	↔ (bidirectional)	11
Tx	↔ (bidirectional)	1
GND	↔ (bidirectional)	8(JD36)/4(JD54)
	↕︎ (tie)	15 5
	↕︎ (tie)	3 7 13