Connection Parameters Needed for HMI/cMT Products to Communicate with Vigor VS Series using EBPro (EasyBuilder Pro)

Introduction

All Maple Systems HMI Touch Screens programmed with EBPro (EasyBuilder Pro), including every cMT X Series and cMT Series model, are compatible with Vigor VS Series. Configure your Controller and HMI/cMT with the following parameters to establish reliable communication.

Supported Series: VIGOR VS Series and VS-ENET-EC Ethernet Module

Website: www.vigorplc.com.tw

HMI Setting

Parameters	Recommended	Options
PLC type	VIGOR VS Series
PLC I/F	RS485 2W	RS232, RS485 2W, USB, Ethernet
Baud rate	19200	300 ~ 115200
Data bits	8
Parity	None
Stop bits	1
PLC sta. no.	0	0 ~ 254
Port no.	1000

*Support communications between HMI and PLC in pass-through mode

*Set LW-9903 to 2 to enhance the speed of download/upload PLC program in pass-through mode

PLC Setting

Protocol: VS Computer Link Slave (TCP or UDP Server)

Device Address

Bit/Word	Device Type	Format	Range
B	`X`	OOO	0 ~ 571
B	`Y`	OOO	0 ~ 571
B	`M`	DDDD	0 ~ 8191
B	`S`	DDDD	0 ~ 4095
B	`SM`	DDDD	9000 ~ 9511
B	`D_Bit`	DDDDh	0 ~ 8999f
B	`R_Bit`	DDDDDh	0 ~ 25999f
B	`T_Coil`	DDD	0 ~ 511
B	`T_Contact`	DDD	0 ~ 511
B	`C_Coil`	DDD	0 ~ 255
B	`C_Contact`	DDD	0 ~ 255
W	`XW`	OO	0 ~ 21
W	`YW`	OO	0 ~ 21
W	`MW`	DDD	0 ~ 511
W	`SW`	DDD	0 ~ 255
W	`D`	DDDD	0 ~ 8999
W	`SD`	DDDD	9000 ~ 9511
W	`R`	DDDDD	0 ~ 25999
W	`T`	DDD	0 ~ 511
W	`C`	DDD	0 ~ 199
DW	`C_32Bit`	DDD	200 ~ 255

Wiring Diagram

NOTE: The serial port pin assignments may vary between HMI models.

Diagram 1: RS-232

HMI	Direction	PLC
Pin assignments		CP2 RS232 terminal
Rx	↔ (bidirectional)	TX
Tx	↔ (bidirectional)	RX
GND	↔ (bidirectional)	SG

Diagram 2: RS-485 2W

HMI	Direction	PLC
Pin assignments		CP1 RS485 2W terminal
Data-	↔ (bidirectional)	D-
Data+	↔ (bidirectional)	D+
GND	↔ (bidirectional)	SG