Introduction
All Maple Systems HMIs programmed with EBPro (EasyBuilder Pro), including every cMT X Series and cMT Series model, are compatible with Moeller XC-CPU101. Configure your Controller and HMI/cMT with the following parameters to establish reliable communication.
Supported Series: MOELLER XC100/200 series
Website: www.moeller.net
HMI Settings
| Parameters | Recommended | Options |
|---|---|---|
| PLC type | Moeller XC-CPU101 | |
| PLC I/F | RS232 | |
| Baud rate | 38400 | 4800 ~ 57600 |
| Data bits | 8 | |
| Parity | None | |
| Stop bits | 1 | |
| PLC sta. no. | 1 |
Device Address
| Bit/Word | Device type | Format | Range | Note |
|---|---|---|---|---|
| B | IX | DDo | 0 ~ 157 | |
| B | QX | DDo | 0 ~ 157 | |
| B | MX | DDDDo | 0 ~ 40957 | |
| B | MW_Bit | DDDDo | 0 ~ 40957 | |
| W | IW | DD | 0 ~ 15 | |
| W | QW | DD | 0 ~ 15 | |
| W | MW | DDDD | 0 ~ 4095 |
Wiring Diagram
NOTE: The serial port pin assignments may vary between HMI models.
RS-232
| HMI | Direction | PLC |
|---|---|---|
| Pin assignments | RS232 8P RJ45 Male |
|
| Rx | ↔ (bidirectional) | 5 TD |
| Tx | ↔ (bidirectional) | 8 RD |
| GND | ↔ (bidirectional) | 4 GND |