Introduction
All Maple Systems HMIs programmed with EBPro (EasyBuilder Pro), including every cMT X Series and cMT Series model, are compatible with a Mitsubishi Q02/Q02H. Configure your Controller and HMI/cMT with the following parameters to establish reliable communication.
Supported Series; Mitsubishi Q02/Q02H CPU port.
Website: http://www.mitsubishi-automation.com
HMI Settings
| Parameters | Recommended | Options | Notes |
|---|---|---|---|
| PLC type | Mitsubishi Q02/02H | ||
| PLC I/F | RS232 | RS485 4W, RS232 | |
| Baud rate | 115200 | 115200 only | |
| Data bits | 8 | ||
| Parity | Odd | ||
| Stop bits | 1 | ||
| PLC sta. no. | 0 | ||
| Online simulator | YES | ||
| Extend address mode | NO | ||
| Broadcast command | NO |
NOTE: Supports communications between HMI and PLC in pass-through mode.
NOTE: Set LW-9903 to 2 to enhance the speed of download/upload PLC program in pass-through mode.
Device Address
| Bit/Word | Device Type | Format | Range | Memo |
|---|---|---|---|---|
| B | SM | DDDD | 0 ~ 2047 | |
| B | X | HHHH | 0 ~ 1fff | Input Relay |
| B | Y | HHHH | 0 ~ 1fff | Output Relay |
| B | M | DDDDD | 0 ~ 61439 | Internal Relay |
| B | L | DDDDD | 0 ~ 32767 | Latch Relay |
| B | F | DDDDD | 0 ~ 32767 | Annunciator |
| B | V | DDDDD | 0 ~ 32767 | Edge Relay |
| B | B | HHHH | 0 ~ 7fff | Link Relay |
| B | TC | DDDDD | 0 ~ 23087 | Timer Coil |
| B | SS | DDDDD | 0 ~ 23087 | Retentive Timer Contact |
| B | SC | DDDDD | 0 ~ 23087 | Retentive Timer Coil |
| B | CS | DDDDD | 0 ~ 23087 | Counter Contact |
| B | CC | DDDDD | 0 ~ 23087 | Counter Coil |
| B | SB | HHH | 0 ~ 7ff | Special Link Relay |
| B | S | DDDD | 0 ~ 8191 | Step Relay |
| B | DX | HHHH | 0 ~ 1fff | Direct Input |
| B | DY | HHHH | 0 ~ 1fff | Direct Output |
| B | TS | DDDD | 0 ~ 2047 | Timer Contact |
| B | D_Bit | DDDDDDDh | 0 ~ 4212735f | |
| B | ZR_Bit | HHHHHh | 0 ~ fe7fff | |
| B | ZR_Dec_Bit | DDDDDDDh | 0 ~ 1042431f | |
| W | W | HHHH | 0 ~ 657f | Link Register |
| W | TN | DDDDD | 0 ~ 23087 | Timer Current Value |
| W | SN | DDDDD | 0 ~ 23087 | Retentive Timer Current Value |
| W | CN | DDDDD | 0 ~ 23087 | Counter Current Value |
| W | R | FFDDDDD | 0 ~ 3132767 | File Register (FF: File No.) |
| W | SW | HHH | 0 ~ 7ff | Special Link Register |
| W | Z | DD | 0 ~ 15 | Index Register |
| W | ZR | HHHHH | 0 ~ fe7ff | File Register |
| W | ZR_decimal_addr | DDDDDDD | 0 ~ 1042431 | |
| W | D | DDDDDDD | 0 ~ 4212735 | Data Register |
Wiring Diagrams
NOTE: The serial port pin assignments may vary between HMI models.
6P Mini-DIN: Q02 CPU port RS232
The following is the view from the soldering point of a connector.
RS-232
| HMI | Direction | PLC |
|---|---|---|
| Pin assignments | RS232 6P Mini-DIN Male | |
| Rx | ↔ (bidirectional) | 1 |
| Tx | ↔ (bidirectional) | 2 |
| GND | ↔ (bidirectional) | 4 |
| ↕︎ (tie) | 5 6 |