Introduction
All Maple Systems HMIs programmed with EBPro (EasyBuilder Pro), including every cMT X Series and cMT Series model, are compatible with a Mitsubishi Q00J CPU. Configure your Controller and HMI/cMT with the following parameters to establish reliable communication.
Supported Series: Mitsubishi Q00J CPU
HMI Settings
| Parameters | Recommended | Options | Notes |
|---|---|---|---|
| PLC type | Mitsubishi Q00J | ||
| PLC I/F | RS232 | CPU port | |
| Baud rate | 115200 | 9600, 19200, 38400, 57600, 115200 | |
| Data bits | 8 | ||
| Parity | Odd | ||
| Stop bits | 1 | ||
| PLC sta. no. | |||
| Online simulator | NO | ||
| Extend address mode | NO |
NOTE: Supports communications between HMI and PLC in pass-through mode.
NOTE: Set LW-9903 to 2 to enhance the speed of download/upload PLC program in pass-through mode.
Device Address
| Bit/Word | Device | Format | Range |
|---|---|---|---|
| B | SM | DDDD | 0 ~ 1023 |
| B | X | HHH | 0 ~ 7FF |
| B | Y | HHH | 0 ~ 7FF |
| B | M | DDDDD | 0 ~ 61439 |
| B | L | DDDD | 0 ~ 2047 |
| B | F | DDDD | 0 ~ 1023 |
| B | V | DDDD | 0 ~ 1023 |
| B | B | HHH | 0 ~ 7FF |
| B | SB | HHH | 0 ~ 3FF |
| B | D_Bit | DDDDDDDh | 0 ~ 4212735f |
| W | SD | DDDD | 0 ~ 1023 |
| W | D | DDDDDDD | 0 ~ 4212735 |
| W | W | HHH | 0 ~ 7FF |
| W | SW | HHH | 0 ~ 3FF |
| W | Z | D | 0 ~ 9 |
| W | C | DDD | 0 ~ 511 |
| W | T | DDD | 0 ~ 511 |
Wiring Diagram
NOTE: The serial port pin assignments may vary between HMI models.
The following is the view from the soldering point of a connector.
RS-232
| HMI | Direction | PLC |
|---|---|---|
| Pin assignments | RS232 6P Mini-Din Male | |
| Rx | ↔ (bidirectional) | 1 |
| Tx | ↔ (bidirectional) | 2 |
| GND | ↔ (bidirectional) | 4 |