Introduction
All Maple Systems HMIs programmed with EBPro (EasyBuilder Pro), including every cMT X Series and cMT Series model, are compatible with HeFei ShenNong Motor Motor Drive. Configure your Controller and HMI/cMT with the following parameters to establish reliable communication.
Website: http://www.ahsngd.com/
HMI Settings
| Parameters | Recommended | Options | Notes |
|---|---|---|---|
| PLC type | HeFei ShenNong Motor | ||
| PLC I/F | RS485 4W | ||
| Baud rate | 9600 | ||
| Data bits | 8 | ||
| Parity | None | ||
| Stop bits | 1 | ||
| PLC sta. no. | 1 |
Device Address
| Bit/Word | Device type | Format | Range | Memo |
|---|---|---|---|---|
| W | ADDR00 | H | 1 ~ D | |
| W | ADDR01 | H | 1 ~ D | |
| W | ADDR02 | H | 1 ~ D | |
| W | ADDR03 | H | 1 ~ D | |
| W | ADDR04 | H | 1 ~ D | |
| W | ADDR05 | H | 1 ~ D | |
| W | ADDR06 | H | 1 ~ D | |
| W | ADDR07 | H | 1 ~ D | |
| W | ADDR08 | H | 1 ~ D | |
| W | ADDR09 | H | 1 ~ D | |
| W | ADDR0a | H | 1 ~ D | |
| W | ADDR0b | H | 1 ~ D | |
| W | ADDR0c | H | 1 ~ D | |
| W | ADDR0d | H | 1 ~ D | |
| W | ADDR0e | H | 1 ~ D | |
| W | ADDR0f | H | 1 ~ D | |
| W | ADDR3f | H | 0 ~ b | |
| W | DATAn | D | 0 ~ 5 |
Wiring Diagram
NOTE: The serial port pin assignments may vary between HMI models.
RS-485 4W (RS422 terminal)
| HMI | Direction | PLC |
|---|---|---|
| Pin assignments | RS422 terminal | |
| Rx- | ↔ (bidirectional) | Tx- |
| RX+ | ↔ (bidirectional) | Tx+ |
| Tx- | ↔ (bidirectional) | Rx- |
| Tx+ | ↔ (bidirectional) | Rx+ |
| GND | ↔ (bidirectional) | GND |