Connection Parameters Needed for HMI/cMT Products to Communicate with Chong Hui Controlwell MD Series using EBPro (EasyBuilder Pro)

Introduction

All Maple Systems HMIs programmed with EBPro (EasyBuilder Pro), including every cMT X Series and cMT Series model, are compatible with Chong Hui Controlwell MD Series. Configure your Controller and HMI/cMT with the following parameters to establish reliable communication.

Supported Series: ControlWell MC3U-32T-A

HMI Setting

Parameters	Recommended	Options	Notes
PLC type	CHONG HUI Controlwell MD Series
PLC I/F	RS232	RS232/RS485/Ethernet
Baud rate	19200	9600 ~ 57600
Data bits	8	7, 8
Parity	Even	Even, Odd, None
Stop bits	1	1, 2
PLC sta. no.	1	1-255	Must match PLC port setting.
Port no.	5000		Ethernet only.

Device Address

Bit/Word	Device type	Format	Range
B	`M`	DDDDD	0 ~ 79999
B	`X`	OOOOo	0 ~ 25707
B	`Y`	OOOOo	0 ~ 25707
B	`S`	DDDD	0 ~ 7999
B	`SM`	DDDD	0 ~ 7999
B	`T`	DDDD	0 ~ 7999
B	`C`	DDDD	0 ~ 7999
B	`HT`	DD	0 ~ 39
B	`HC`	DD	0 ~ 39
B	`D`	DDDDD	0 ~ 79999
B	`AI`	DDDD	0 ~ 2199
W	`AQ`	DDDD	0 ~ 2199
W	`SD`	DDDD	0 ~ 4999
W	`TD`	DDDD	0 ~ 7999
W	`CD`	DDDD	0 ~ 7999
W	`HTD`	DD	0 ~ 39
W	`HCD`	DD	0 ~ 39
W	`FD`	DDDD	0 ~ 9999
W	`FDD`	DDDD	0 ~ 4999

Wiring Diagram

NOTE: The serial port pin assignments may vary between HMI models.

Diagram 1:

RS-232 (PLC COM1: RS-232 8P Mini-DIN)

The following is the view from the soldering point of a connector.

RS-232 8P Mini-DIN connector viewed from the soldering point, showing circular pin layout.

HMI	Direction	PLC
Pin assignments		COM1 RS232 8P Mini-Din Male
Rx	↔ (bidirectional)	5 TX
Tx	↔ (bidirectional)	4 RX
GND	↔ (bidirectional)	3/8 GND

Diagram 2:

RS-485 2W (PLC COM3: RS-485 2W Terminal)

HMI	Direction	PLC
Pin assignments		COM3 RS485 2W Terminal
Data-	↔ (bidirectional)	Data-
Data+	↔ (bidirectional)	Data+
GND	↔ (bidirectional)	GND

Diagram 3:

Ethernet cable: