Introduction
All Maple Systems HMI Touch Screens programmed with EBPro (EasyBuilder Pro), including every cMT X Series and cMT Series model, are compatible with TECHSOFT Intelligent Servo. Configure your Controller and HMI/cMT with the following parameters to establish reliable communication.
Supported Series: Intelligent Servo supports IDM640, IDM240
Website: technosoftmotion.com
HMI Settings
| Parameters | Recommended | Options | Notes |
|---|---|---|---|
| PLC type | Intelligent Servo | ||
| PLC I/F | RS232 | ||
| Baud rate | 9600 | 9600~115200 | |
| Data bits | 8 | 7 or 8 | |
| Parity | None | Even, Odd, None | |
| Stop bits | 1 | 1 or 2 | |
| PLC sta. no. | 1 |
Device Addresses
| Bit/Word | Device type | Format | Range | Memo |
|---|---|---|---|---|
| W | Register_32bit | HHHH | 0 ~ 270f | 32bit signed |
| DW | Register_H | HHHH | 0 ~ 270f | 32bit Hex |
| W | UPD | HHHHH | 0 ~ 1869f | Send UDP command |
| W | STOP | HHHHH | 0 ~ 1869f | Send STOP command |
Wiring Diagram
NOTE: The serial port pin assignments may vary between HMI models.
RS-232
| HMI | Direction | PLC |
|---|---|---|
| Pin assignments | RS232 6P Mini-Din Male | |
| Rx | ↔ (bidirectional) | 2 TX |
| Tx | ↔ (bidirectional) | 3 RX |
| GND | ↔ (bidirectional) | 5 GND |