To create a Normally Closed Contact (as well as a one-shot, rising edge, falling edge, etc.) contact or a negative coil (as well as a latch bit, reset bit, etc.) in MAPware-7000, you will want to place a regular contact or coil in your logic, hover over it with your cursor and either press the spacebar, or the “Swap Item Style” button on the sidebar.
Software Downloads & Upgrades
Manuals & Guides
- MAPware-7000 Programming Manual
- MAPware-7000 Getting Started Guide
- IEC 61131-3 Programming Guide for MAPware-7000
- I/O Module Guide for HMC2000, HMC3000, HMC4000 Series
Tech Notes
Solutions
Videos