How do I setup the IP address of an HMI and the development PC to allow Ethernet communications?

Refer to Tech Note 5077, “IP Addresses of an HMI and a PLC” on how to set the IP address of the Maple Systems HMI, set the IP address of the PC, change the setting on the Internet Protocol dialog box, and setup and configuration settings. Note that configuring IP addresses while connected to an established network can interrupt communication if care is not taken. Consult a networking specialist before proceeding.

Software Downloads & Upgrades

• EBPro

Manuals & Guides

• EBPro Programming Manual

Tech Notes

• IP Addresses of an HMI and a PC
• Multiple HMIs connecting to one PLC
• Target PLC IP Address Updated Using the HMI Screen
• Using the Modbus Gateway

Controller Information Sheets

• Controller Information Sheets

Communication Cables

• Communication Cables