Introduction
All Maple Systems HMIs programmed with EBPro (EasyBuilder Pro), including every cMT X Series and cMT Series model, are compatible with Schneider Electric IMS Servo. Configure your Controller and HMI/cMT with the following parameters to establish reliable communication.
Supported Series: Schneider Lexium MDrive
Website: motion.schneider-electric.com
HMI Settings
| Parameters | Recommended | Options | Notes |
|---|---|---|---|
| PLC type | Schneider IMS SERVO | ||
| PLC I/F | RS232 | ||
| Baud rate | 9600 | ||
| Data bits | 8 | ||
| Parity | Even | ||
| Stop bits | 1 | ||
| PLC sta. no. | 1 |
Device Address
| Bit/Word | Device type | Format | Range | Memo |
|---|---|---|---|---|
| B | BIT | HHHHo | 0 ~ FFFF7 | |
| W | WORD | HHHH | 0 ~ FFFF | |
| DW | DWORD | HHHH | 0 ~ FFFF | |
| Byte | BYTE | HHHH | 0 ~ FFFF |
Wiring Diagram
NOTE: The serial port pin assignments may vary between HMI models.
RS-232
| HMI | Direction | PLC |
|---|---|---|
| Pin assignments | RS232 9P D-Sub Female | |
| Rx | ↔ (bidirectional) | 3 |
| Tx | ↔ (bidirectional) | 2 |
| GND | ↔ (bidirectional) | 5 |