Introduction
All Maple Systems HMIs programmed with EBPro (EasyBuilder Pro), including every cMT X Series and cMT Series model, are compatible with Motrona MC700. Configure your Controller and HMI/cMT with the following parameters to establish reliable communication.
Supported Series: motrona MC700
Website: http://motrona.net/index.html
HMI Setting
| Parameters | Recommended | Options | Notes |
|---|---|---|---|
| PLC type | motrona MC700 | ||
| PLC I/F | RS232 | ||
| Baud rate | 9600 | 9600 ~ 38400 | |
| Data bits | 7 | 7, 8 | |
| Parity | Even | Even, Odd, None | |
| Stop bits | 1 | 1, 2 | |
| PLC sta. no. | 11 | 11 ~ 99 |
Device Address
| Bit/Word | Device type | Format | Range | Note |
|---|---|---|---|---|
| B | ERCD_Bit |
HHHH | 0 ~ FFFF | |
| B | CODE_Bit |
HHHHdd | 0 ~ FFFF31 | |
| W | ERCD |
HHHH | 0 ~ FFFF |
Wiring Diagram
NOTE: The serial port pin assignments may vary between HMI models.
RS-232
| HMI | Direction | PLC |
|---|---|---|
| Pin assignments | RS232 9P D-Sub Female |
|
| Rx | ↔ (bidirectional) | 3 TXD |
| Tx | ↔ (bidirectional) | 2 RXD |
| GND | ↔ (bidirectional) | 5 GND |