The leader in industrial automation and control solutions

Introduction

All Maple Systems HMIs programmed with EBPro (EasyBuilder Pro), including every cMT X Series and cMT Series model, are compatible with Wieland SAMOS PRO. Configure your Controller and HMI/cMT with the following parameters to establish reliable communication.

Supported Series: Samos Pro controllers SP-SCON-P1-K, SP-SCON-NET-PA-K

Website: wieland-electric.com

HMI Settings

ParametersRecommendedOptionsNotes
PLC typeWIELAND SAMOS PRO
PLC I/FRS232
Baud rate1152009600, 19200, 38400, 57600, 115200
Data bits8
ParityNone
Stop bits1
PLC sta. no.0

Device Address

Bit/WordDevice typeFormatRangeMemo
BIDDo0 ~ 127Input
BQDDo0 ~ 127Output
BLogic resultDDo0 ~ 197Logic Result
BRS-232 to Samos ProDDo0 ~ 37RS-232
BSamos Pro to RS-232_BitDDo0 ~ 997
BModule Status Bit Array_BitDDo0 ~ 597
BOperating Data Block_BitDo0 ~ 97
BConfiguration CRCs_BitDDo0 ~ 197
BCPU Module Type Key_BitDDo0 ~ 177
BExtension Modules Type_BitDDDo0 ~ 3377
WRS-232 to Samos ProD0 ~ 2
WSamos Pro to RS-232DD0 ~ 97
WModule Status Bit ArrayDD0 ~ 58
WOperating Data BlockD0 ~ 8
WConfiguration CRCsDD0 ~ 18
WCPU Module Type KeyDD0 ~ 16
WExtension Modules TypeDDD0 ~ 336

Wiring Diagram

NOTE: The serial port pin assignments may vary between HMI models.

RS-232

4-pin Mini-DIN male connector viewed from the soldering side, with numbered pin positions labeled 1 through 6 on the circular face.

The view from the soldering point of a connector.

HMIDirectionPLC
Pin assignmentsCPU0 Port0 4P
Mini-DIN Male
Rx↔ (bidirectional)3 TX
Tx↔ (bidirectional)2 RX
GND↔ (bidirectional)4 GND