Introduction
All Maple Systems HMIs programmed with EBPro (EasyBuilder Pro), including every cMT X Series and cMT Series model, are compatible with Toshiba Machine Provisor TC200. Configure your Controller and HMI/cMT with the following parameters to establish reliable communication.
Supported Series: TOSHIBA MACHINE CO., JAPAN, TCMini
Website: http://www.toshiba-machine.co.jp
HMI Settings
| Parameters | Recommended | Options | Notes |
|---|---|---|---|
| PLC type | TOSHIBA MACHINE Provisor TC200 | ||
| PLC I/F | RS232 | RS232 | In accordance with PLC port |
| Baud rate | 9600 | 9600, 19200 | |
| Data bits | 8 | 7, 8 | |
| Parity | None | Even, Odd, None | |
| Stop bits | 1 | 1, 2 |
Device Address
| Bit/Word | Device | Format | Range | Memo |
|---|---|---|---|---|
| B | R_bit | HHHh | 0 ~ ffff | h : Bit no.(0~f) |
| B | X_bit | HHHh | 0 ~ ffff | h : Bit no.(0~f) |
| B | Y_bit | HHHh | 0 ~ ffff | h : Bit no.(0~f) |
| B | L_bit | HHHh | 0 ~ ffff | h : Bit no.(0~f) |
| B | G_bit | HHHh | 0 ~ ffff | h : Bit no.(0~f) |
| B | H_bit | HHHh | 0 ~ ffff | h : Bit no.(0~f) |
| B | T_bit | HHHh | 0 ~ ffff | h : Bit no.(0~f) |
| B | C_bit | HHHh | 0 ~ ffff | h : Bit no.(0~f) |
| B | S_bit | HHHh | 0 ~ ffff | h : Bit no.(0~f) |
| B | E_bit | HHHh | 0 ~ ffff | h : Bit no.(0~f) |
| W | P | HHH | 0 ~ fff | |
| W | V | HHH | 0 ~ fff | |
| W | X | HHH | 0 ~ fff | |
| W | Y | HHH | 0 ~ fff | 0 ~ fff |
| W | D | HHH | 0 ~ fff | |
| W | R | HHH | 0 ~ fff | |
| W | L | HHH | 0 ~ fff | |
| W | B | HHH | 0 ~ fff | |
| W | G | HHH | 0 ~ fff | |
| W | H | HHH | 0 ~ fff | |
| W | T | HHH | 0 ~ fff | |
| W | C | HHH | 0 ~ fff | |
| W | S | HHH | 0 ~ fff | |
| W | E | HHH | 0 ~ fff |
Wiring Diagram
RS-232
NOTE: The serial port pin assignments may vary between HMI models.
| HMI | Direction | PLC |
|---|---|---|
| Pin assignments | TC mini series RS232 9P D-Sub Male | |
| Rx | ↔ (bidirectional) | 2 TX |
| Tx | ↔ (bidirectional) | 3 RX |
| GND | ↔ (bidirectional) | 5 GND |
| ↕︎ (tie) | 7 8 |