If using Ethernet, make sure the PC can connect to the HMC by “PINGing” the IP address of the HMC.
If using USB, confirm that “HMI USB Device” shows up in Windows Device Manager. You may want to refer to Tech Note 7017 AFTER considering the next step.
On the HMC screen, delete the firmware by holding the top left corner of the screen while powering on. Then delete the application by holding the top right corner of the screen while powering on. Now try downloading the project to the screen again.
Software Downloads & Upgrades
Manuals & Guides
- HMC Series Installation Guide
- MAPware-7000 Programming Manual
- MAPware-7000 Ladder Logic Guide
- Mapware-7000 Getting Started Guide
- HMC3000 I/O Module Guide
- HMC7000 I/O Module Guide
- MAPware-7000 IEC61131 Programming Guide
Videos
- Part 1: Introduction and Installation
- Part 2: Creating a Native Ladder Project
- Part 3: Adding and Initializing Tags
- Part 4: Adding Logic
- Part 5: Creating an HMI Screen
- Part 6: Duplicationg an HMI Screen
- Part 7: Downloading and Testing the Project
- Part 8: Creating an IEC Project
- Part 9: Creating a UDFB
- Part 10: Adding a Structure Text UDFB
- Part 11: Adding Power Up and Main Routine Logic
- Part 12: Creating Screen Objects
- Part 13: Downloading the Project and Online Monitoring
Sample Projects